Clik here to view.
How-to: Fixing Yaw Drift
Saw this on FB thought it would be useful so sharing it, credit to Joe. So here it is. Just a quick run-down on how to correct yaw drift issue. Steps apply to CleanFlight and BetaFlight-enabled FCs....
View ArticleClik here to view.
Red rotor OSD PDB
Just received my RED Rotor OSD PDB It's pretty easy to connect: camera goes in , and on the other side to the VTX. Both get power from the PDB, aswell is there a 5V output for the Naze32. Keep in...
View ArticleClik here to view.
Power Distribution Boards
Just thought I would write a little something about PDB's. They come in all sizes and flavours, with each manufacturer claiming theirs is better than everyone else's. So, do you actually need a PDB ?...
View ArticleBaterry Change Problems
Every time I change batteries on my quad I get erratic flying and uncontrolled takeoff. What do I have to do to solve this problem. Frustrating
View Article+1 Reputation - Thanks!
First off, Thank you to those of you that gave me my first three +1 Reputation today. I appreciate that my taking the time to contribute back to the community is appreciated! Thank you that you cared...
View ArticleClik here to view.
Thread Rating Question
I looked, but as of yet haven't found what is the purpose of "thread" rating with the 1 to 5 stars? Does someone have some insight as to the purpose and usefulness of this feature? Think I found my own...
View ArticleClik here to view.
Runcam Swift FPV Camera
Runcam is releasing a new fpv cam that can match the HS1177 in terms of size, but with greater performance. It's essentially the same camera as the Runcam SkyPlus, but smaller. Dimension: 26mm x 26mm...
View ArticleClik here to view.
Tried Fitting A Black Box
So i fitted my quad with a blackbox but i am unsure on how you get the data off it???? Any Helps Appreciated
View Articlequad won't fly straight, out of sync esc?
Hey Folks, I could really use your help. I'm running betaflight on a cc3d board. I was finally able to flash my esc with blheli 14.4 These are the esc's I have:...
View ArticleHi and Hello and Welcome
There's no introduction forum!!??? What!!??? Anyway, I saw Oscar post a link to this forum on the FB group and I immediately joined. Might be old news to some of you but I'm usually so busy it's hard...
View ArticleQuanum Elite QE58-2 5.8GHz 25-200mW VTX: Bench Review & RF Power Measurements
Hi guys! In this video we do a full bench review of the Quanum Elite QE58-2 5.8GHz 40CH video transmitter with selectable 25 or 200mW power. After the unboxing, we measure size, weight, working...
View ArticleChargers, Power Supplies and headaches/wallet aches
OK so my Radiolink CB86-Plus is slowing me down a LOT now that I am actually wanting to fly more. I am researching around for good chargers and found two that are probably what I am going to decide...
View ArticleClik here to view.
Do you display your quads when not flying?
Image 14.jpg (Size: 186.51 KB / Downloads: 1)
View Articlehelp please
Hi Oscar, I found your blog last month and I have read probably all posts. Great info for beginners! Unfortunately I already had all my parts purchased, so my config is: -qav250 clone -cc3d running...
View ArticleESC Amp Rating - Performance
How does the Amp rating of an ESC affect the battery and motor performance?
View ArticleSome doubts about parallel Charging
I am still a bit confused about parallel charging.. for example: if i have 2 lipos one of them is 3.7V/cell and the other one is 3.5V/cell, can i charge them together?
View ArticleNew Lipo: do you Repeat Charge / Discharge a few times before use?
Anyone who actually charges, discharges, charges, discharges their new lipo's etc before use? I mostly just charge them put put them on the quad and go. but then I heard there is something called break...
View ArticleZMR quick change setup
Just wanted to see what you guys thought of a quick change setup for quads. This is for the Zmr but really it could be done with any quad. The lumenier pdb is a good idea to eliminate soldering so I...
View ArticleClik here to view.
STOP POSTING
Stop POSTING ! , Have to give myself a chance at winning the ESC's ya know.
View ArticleClik here to view.
Building an X racer
I’ve been cranking out a new build around every month I have been with this hobby. For #6, I decided to do a proper racer with the heavily hyped X frames. Parts List Frame: SpaceOne FPV Formula One 220...
View Article/pic9814888.png)
/fit-in/580x348/filters:format(webp)/english-betterindia/media/media_files/2026/09/17/balaghat-4-2026-09-17-19-01-31.png)
